Blasterparts - Modification spring for Nerf N-Strike Elite [XD] Firestrike
Thanks to the Blasterparts Modification Spring, The Nerf N-Strike Elite [XD] Firestrike is a backup blaster to be repected.
Firestrike with Modding Spring – one shot, one hit
With the Nerf N-Strike Elite the Nite Finder has received a worthy successor. Like the Nite Finder, the Firestrike has a lot of headroom concerning performance, which you can exploit using the Blasterparts Modification Spring. The Blasterparts Modification Spring fits the regular Elite as well as the XD-Variant of the Firestrike.
The Firestrike after Blasterparts Spring Mod
- Equivalent mass of spring: 6kg
- Firing range increase: 80%
- Muzzle velocity increase: 100%
- Difficulty level of spring installation: moderate
Problems installing the Modding-Spring? Here’s the solution
To install the Blasterparts Modification Spring into the Nerf N-Strike Elite Firestrike or the Nerf N-Strike Elite XD Firestrike, the blaster has to be completely unscrewed. The Spring is attached to the plunger rod and is hold by the plunger cap. Instead of being screwed to the rod, the cap is engaged with snap locks. You will have to push down these locks with a small screwdriver or a similar tool. This can be a little tricky. It is nearly unavoidable to damage the locks somehow. The cap will be locked perfectly nevertheless. If the cap has been removed, the spring can be exchanged without any problems. The cap can simply be stuck back to the rod and will lock in position. We recommend the usage of some acid free oil or silicon spray on the sealing ring to enable better sliding and sealing. This will have a remarkable effect on the performance of the blaster. Now you can screw the blaster back together and be amazed.
- Modification Spring, Manual