Blasterparts - Modification Spring for Nerf N-Strike Elite Disruptor
This revolver has some resources to dig out.
- Equivalent mass of spring: 6kg
- Firing range increase: about 30%
- Muzzle velocity increase: about 50%
- Difficulty level of spring installation: moderate
As a successor to the Strongarm, the Disruptor achieves slightly better Modding Results.
The Modification Spring with an equivalent mass of 6kg provides a descent performance boost for the Nerf N-Strike Elite Disruptor without putting too much stress on the mechanics. The projectiles fly faster and travel a much longer distance.
Don't be afraid of all those little springs
Before removing the internals make sure you know where each part belongs. Keep in mind the position of the small springs: One at the trigger, two in the main compartment. There is one spring hiding under the catch in the back.
As an unexperienced modder you should find a picture of the internals of the blaster in the internet before you start taking the blaster apart.
First remove one half of the sled before you unscrew the blaster.
Now remove the trigger and the catch. Then take out the main compartment and the plunger. Remove the spring by twisting it over the hooks and wind it off. Screw on the new modification spring and lock it into the hooks at the front. Insert the plunger into the plunger tube with the hook at the back facing downwards.
After reinstalling the main compartment place the catch into the back so that it moves up and down gently. Insert the small catch spring through the little window. Then put the trigger back in place and test if the catch moves when you activate the trigger.
- 560481
- Blasterparts
- Blasterparts
- Modification Spring, Manual