Blasterparts - Modification spring for NERF Raider CS-35
The Blasterparts Modification Spring gives new life to your Nerf N-Strike Raider.
Turn the Nerf N-Strike Raider into a real contender again
Thanks to its impressive 35 round drum magazine and its Slam Fire capability, the Nerf N-Strike Raider has been a very effective Blaster. However, due to its age it can't compete with the ranges of newer blasters of the N-Strike Elite or Zombie Strike line. But with the Blasterparts Modification Spring, your opponents will take you and your Raider seriously again!
The 5kg spring does not only increase range but also dart speed. The effect is that your darts can't be dogded anymore.
Features of the Modification Spring for the Nerf N-Strike Raider
- Equivalent mass of spring: 5kg
- Firing range increase: about 100%
- Muzzle velocity increase: about 80%
- Difficulty level of spring installation: moderate
Installing the Blasterparts Modification Spring
Installing the Blasterparts Modification Spring into the Nerf N-Strike Raider is an easy job with a little practice and technical understanding.
Try to avoid using force when you open the blaster. Remove the end cap and the screws in the back half of the blaster, so you can carefully lift the back with a screwdriver as a lever. Pull out the main spring through the hole in the back while keeping the other parts in place. Insert the Modification Spring likewise, close the shell carefully and make sure, all parts are in the right place. Screw on the end cap and test the operation before fastening all screws.
- Modification Spring, Manual